Consult MSDS before use.
Always carry out a test first to ensure the finished result is acceptable.
Clean surface thoroughly until all residues are removed and rinse with clean water.
The surface must be dry before application.
Ensure the surface is above 5°C and below 30°C before applying.
Shake the container well and pour the product neat into the Vulcaseal Spray Applicator
Spray evenly using a fine spray over the entire surface and allow the product to act for 10 minutes.
Use a soft cloth or floor pad to wipe / buff off remaining product.
Allow 2 hours before walking on the surface, full performance is achieved after 48 hours.
Ensure all equipment is cleaned after use.
Reapply every 6 months with a 50% dilution with water to uphold the ultimate level of slip resistance.
Reduces slip hazards on prone surfaces.
Performs in wet conditions.
Does not alter the appearance of the surface.
1 ltr & 5 ltr
8 - 10m² per litre
Surfactants and foaming agents: comply with European Directives EEC 82/242 and 82/243.
24 months from the date of manufacture in original unopened container in a clean, dry area and ideally at 20-25°C.
|Physical State at 20°C||Liquid|
|pH||4 ± 0.5|
|Boiling Point||100 °C|
Health and Safety
Wear safety goggles if splashing is likely.
In case of ingestion do not provoke vomiting.
Contact a doctor or a specialist.
Stone surface with high slip risk.
Result on surface after using Vulcaseal Anti Slip.